rear bag setup?

[spfd68]

Im going to notch and bag my 70 ford. Im not quite sure on how to fabricate the setup. Is there a certain length you need on your bars. Is there a mathmatical formula I need to figure out by measuring? Also I've seen some cantaliever setups where the bag is on the bar behind the axle. Is that a better setup? Does anybody know where I can get some sort of drawing on how to set it up? Thanks

[Xplorer]

Measurements are pretty much where you can fit them on the 4 link and notch setups...
If you are fabricating it you will make it to YOUR specifications.

Cantilever is good, but remember the KISS rule, especially if you havent built one before.

[Taurfibribe]

Ive recieved my mounts and all my kit but you didnt send the bracket........... any chance i can get one sent out?
Thanks

[Taurfibribe]

Not sure on that brand but some use the toe bolt on the spring plate to affix the link, that would move it more forward?

[albulge09]

When you order your kit just select that you have a RHD chassis and we will send you out a steel piece to add to your subframe